12-26
Catalyst 2960 Switch Software Configuration Guide
OL-8603-04
Chapter 12 Configuring VLANs
Configuring VMPS
Entering the IP Address of the VMPS
You must first enter the IP address of the server to configure the switch as a client.
Note
If the VMPS is being defined
for a cluster of switches, enter the address on the command switch.
Beginning in
privileged EXEC mode, follow these steps to enter the IP address of the VMPS:
Note
You must have IP connectivity to the VMPS for dynamic-access ports to work.
You can test for IP
connectivity by pinging the IP address of the VMPS and verifying that you get a response.
Configuring Dynamic-Access Ports on VMPS Clients
If you are configuring a port on a cluster member switch
as a dynamic-access port, first use the
rcommand privileged EXEC command to log in to the cluster member switch.
Caution
Dynamic-access port VLAN membership is for end stations or hubs connected to end stations.
Connecting dynamic-access ports to other switches can cause a loss of connectivity.
Beginning in privileged EXEC mode, follow these steps to configure a dynamic-access port on a VMPS
client switch:
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
vmps server ipaddress
primary
Enter the IP address of the switch acting as the primary VMPS server.
Do'stlaringiz bilan baham: 
