Power Plant Engineering
Fig. 4.31 4.9.1 CYCLONE FIRED BOILERS
Download 3.45 Mb. Pdf ko'rish
|
Power-Plant-Engineering
- Bu sahifa navigatsiya:
- 4.10 WATER WALLS
Fig. 4.31
4.9.1 CYCLONE FIRED BOILERS In cyclone fired boilers the fur-nace is arranged as a horizontal cylinder. The pulverised fuel is bed along the periphery of the cylinder. The hot gases travel axially into the water tube section having a tight helix path. The temperature generated in the combustion zone is quite high and because of this the tubes are coated with fused ash which goes on collecting the ash particles going in the flue gases. The out going gases contain particles less than 20 microns. The cyclone furnaces can successfully burn coals having low ash fusion temperature. The cyclone furnace is operated under combustion air pressure of 700 to 1000 mm of water gauge. Cyclone fired boilers have the following advantages : (i) Quick load variations can be easily handled. (ii) Nearly 55% of ash in coal is burnt in the form of liquid slag. The ash can be removed in the molten form. (iii) The slag can be used as a building material. (iv) Fly-ash problem is reduced to much lower limits. 4.10 WATER WALLS Larger central station type boilers have water cooled furnaces. The combustion space of a fur- nace is shielded wholly or partially by small diameter tubes placed side by side. Water from the boiler is made to circulate through these tubes which connect lower and upper headers of boiler. The provision of water walls is advantageous due to following reasons: (1) These walls provide a protection to the furnace against high temperatures. (2) They avoid the erosion of the refractory material and insulation. (3) The evaporation capacity of the boiler is increased. STEAM POWER PLANT 167 Insulating Concrete Expanded Metal Lath High Temp Plastic Insulation Magnesia Block Casing Touching tubes Cast Refractory Brick Insulation Blanket Insulation Casing Half radiant cast refrectory Tubes Flat refractory Tile High Temperature Insulating Brick Magnesia Block Casing Tangent tubes-flat files. Fig. 4.32. Various Water Walls Arrangement. The tubes are attached with the refractory materials on the inside or partially embedded into it. Fig. 4.32 shows the various water walls arrangement. Download 3.45 Mb. Do'stlaringiz bilan baham: |
Ma'lumotlar bazasi mualliflik huquqi bilan himoyalangan ©fayllar.org 2024
ma'muriyatiga murojaat qiling
ma'muriyatiga murojaat qiling