- Relations switch cable connector from the chassis front panel, LED, internal speakers and ports that were installed in front of the casing when the motherboard. Check your motherboard diagram to locate the right connectors.
Assembling OWN COMPUTER Assembling OWN COMPUTER - Pellet dislodged drive bay cover (space to drive on the casing)
- Enter from the front drive bays with the first set the jumper settings (as master or slave) on the drive.
Assembling OWN COMPUTER - Adjust the position of screw holes in the drive and chassis and then install the drive retaining screws.
- Connect the IDE cable connector to the drive and the connector on the motherboard (the connector is used first primary)
Assembling OWN COMPUTER - 1 until Repeat step 4 for each installation drive.
- If the IDE cable connected to the du drive jumper settings make sure that the difference of the two first drive set as master and the other as slave.
Assembling OWN COMPUTER - Secondary IDE connector on the motherboard can be used to connect two additional drives.
- Floppy drive is connected to a special connector on the motherboard floppy
- Connect the power cable from the power supply to each drive.
Assembling OWN COMPUTER - 9. Install Card Adapter
- A common adapter card is installed video card, sound, network, modem and SCSI adapters. Video card should generally be installed and installed before any other adapter card.
- How to install the adapter:
- Hold the edge of the adapter card, avoid touching the electronic components or circuits. Press the card to plug right into the expansion slot on the motherboard
Do'stlaringiz bilan baham: |
