- HOW TO INSTALLING MOTHERBOARD.
Assembling OWN COMPUTER - 6. Install Power Supply
- Several types of chassis is equipped with power supply. When the power supply has not included the way the installation as follows:
Assembling OWN COMPUTER - Enter the power supply on the shelf at the back of the casing. Connect the four locking screws. Connect the power connector from the power supply to the motherboard. ATX power connector types have only one way of installation so as not to be reversed.
Assembling OWN COMPUTER - For non-ATX type connectors with two separate cables then black ground must be placed side by side and mounted in the middle of the motherboard power connector. Connect the power cord for the fan, if you use the fan for cooling the CPU.
Assembling OWN COMPUTER - 7. Install the motherboard and chassis cable
- After the motherboard installed in the chassis next step is to install the cable I / O on the motherboard and the casing panels.
- Connect the data cable for the floppy drive controller on a floppy connector on the motherboard
Assembling OWN COMPUTER - Connect the IDE cable connector to the primary and secondary IDE on the motherboard.
-
- For non-ATX motherboard. Connect the serial cable and parallel port on the connector on the motherboard. Note the position of pin 1 to install.
Assembling OWN COMPUTER - On the back of the casing there is a hole to install an additional port types of non-slot. Open the lock plate screw holes covered lalumasukkan port to port connectors installed and put screws back.
- When the mouse port not available at the back of the card casing mouse connectors must be installed and connected to the mouse connector on the motherboard.
Do'stlaringiz bilan baham: |
