Installation Manual indd

B. Easy Door Lock Program
(Push button will not operate until Easy Door Lock is programmed)
1) Decide on a passcode, a 4 digit number. (i.e. 1234)
2) Step into the vehicle.
3) Open the driver side door.
4) Press the “Start” button so that it is on the “Ignition ON” position.
5) Step out of the vehicle.
6) Knock on the Easy Door Lock a few times until you see all the LED lights flash.
7) LED light will now move from 1 to 0.
(Each number will be lit for 2 seconds)
8) Knock on the pad when the number to your passcode is lit.
(Each time a number is entered, the LED light will restart from the 1 position)
i.e.) On a passcode for 1234.
a. Tap when the LED light is lit on the 1.
b. LED light will restart from the 1 position and move onto 2.
c. Tap when the LED light is lit on the 2.
d. LED light will restart from the 1 position and move onto 2 and 3.
e. Tap when the LED light is lit on the 3.
f. LED light will restart from the 1 position and move onto 2, 3 and 4.
g. Tap when the LED light is lit on the 4.
9) Once all 4 number passcodes are entered, the siren will beep once and the
parking light will flash once.
10) Easy Door Lock programming is now complete.

---

20
INSTALLATION GUIDE
21
INSTALLATION GUIDE
U S A
U S A
6. How to Program the Options
A. To Program
1) Review the options above and remember the button sequence required for
that specific option.
2) Press the I + IV ( + ) button simultaneously for 2 seconds to begin the
programming mode. The vehicle’s parking lights will flash once and chirp 
once, stating that it is now in programming mode.
3) Immediately press the two corresponding buttons (one after another).
i.e.) Sound Select option  press I ( ), then IV ( ).
4) Within 3 seconds, the vehicle’s parking lights will flash as well as chirp;
corresponding to the first button pressed followed by chirp(s) and flashes
matching the second button pressed. 
i.e.) Sound Select option  vehicle chirps once with one flash (since the I ( )
button was pressed), followed by 4 chirps and 4 flashes (since the IV button 
was pressed).
5) To end programming mode, press I + IV ( + ) for 2 seconds. It will also
end programming with 30 seconds of inactivity. The vehicle’s parking lights will
flash once and chirp once, stating that it is now out of the programming mode.