Installation Manual indd

 
2. Noise Sensing LED
Noisy Sensing LED
LED
The LED on the cover of the main controller unit is lit when the engine is running 
and the light is turned off when the engine is off.
4. Programming
IMPORTANT!
 
These steps must be completed in order for the
product to operate properly.
A. Remote Control Registration
1) Press the “Start” button (OFF  ACC  ON) 4 times; “ON” light should be
displayed. 
(Parking light flash once, ready to program the remotes)
2) Press the I or button on the 1st remote.
3) Then press the I or button on the 2nd remote.
(When the lock button is pressed on the remote, paking light flash once)
4) Remote programming is now complete.

---

18
INSTALLATION GUIDE
19
INSTALLATION GUIDE
U S A
U S A
C. Smart Door Lock Registration
1) Open the driver side door.
2) Make sure the Push-to-Start button is set to the “OFF” position. 
(“START” light should be lit)
3) Press the II or button for 2 seconds on the 1st remote. 
(Siren will beep twice)
4) Press the II or button for 2 seconds on the 2nd remote. 
(Siren will beep twice)
5) Smart Door programming is now complete.
5. Remote/Push Button Start Diagnostics
When the remote start function is activated and the vehicle emits an error tone
(3 chirps); you have the ability to see what the cause of the no-start situation is by 
counting the amount of flashes of the parking lights from the vehicle.
Number of parking 
lights flashes
Cause of Error
1
Engine is on
2
Ignition is to the ON position
3
Door is open (Door wire is active) or Knock Sensor is not 
programmed
4
Trunk is open (Trunk wire is active)
5
Brake is being pressed (Brake wire is active)
6
CN4/7 wire is not connected
7
Manual transmission mode is enabled and not initialized
8
Parking brake / Emergency brake is off
Neutral safety wire has no ground or the neutral safety switch 
is off