Installation Manual indd

---

INSTALLATION GUIDE
U S A
EP400 / E8-B
www.Easycar-USA.com
www.Easycar-USA.com

---

---

4
INSTALLATION GUIDE
5
INSTALLATION GUIDE
U S A
U S A
1. Wire Connection Guides 
➢

Heavy Gauge, 10-pin Connector (CN1)
There are 6 heavy gauge wires coming from the large 6-pin connector. They are 
used to energize the ignition circuits in the vehicle. It is crucial to ensure that these 
connections are capable of handling the current demands. For this reason, Scotch-
Locks, T-taps and other such connectors are strongly discouraged.
CN1/1 
YELLOW STARTER 
OUTPUT
After cutting the starter wire, connect the YELLOW wire to the ignition switch wire.
This wire supplies power to the starter motor output.
CN1/2 
WHITE 
(+) IGNITION 2
This wire is the polarity feed for the ignition 2. (+) 12V with the key ON and 0V in 
the START position. This wire supplies power to subsidiary accessories such as car 
audio, lights and to climate control such as air conditioner and heater. If the vehicle 
is not equipped with this wire, do not connect it.
 CN1/3
GREEN
(+) IGNITION 1 INPUT/OUTPUT
Search for a 0 volt wire with the key in the ACC position, (+) 12V wire with the key on 
the ON position, and (+) 12V wire with the key on the START position.
CN1/4
RED/WHITE 
(+) MAIN POWER 2
Connect to constant (+) 12V source, minimum 30A capacity.
CN1/5
BLUE (+) 
ACC 
Search for a wire that is 0V with the key in the OFF position, (+) 12V with the key on 
the ACC & ON position, and 0V with the key on the START position.