Installation Manual indd

IMPORTANT!
 
Always verify that the vehicle cannot be started in ANY drive 
gear and that the override switch is functioning properly.
 CN4/7 
BLUE 
(+) SYSTEM TURN ON
Connect this wire to the (+) 12V. This is Push Button Start key signal wire.
 CN4/8
ORANGE/BLACK 
(-) DIESEL WAIT TO START INPUT
Connect this wire to the wire in the vehicle that sends the signal to turn on the Wait-
To-Start bulb in the dashboard. In most diesels the wire is negative (ground turns 
on the bulb) and the ORANGE/BLACK wire can be directly connected to the wire in 
the vehicle. If the vehicle uses a positive wire (12V to turn on the bulb) a relay must 
be used to change the polarity.
 CN4/9 
VIOLET/BLACK 
(-) TRUNK TRIGGER INPUT
This input responds with an instant (-) trunk trigger.

---

12
INSTALLATION GUIDE
13
INSTALLATION GUIDE
U S A
U S A
➢

Easy Door Lock Sensor, LED Light Connector (CN5)
Easy Door Lock Sensor 
Doors can be locked (armed) or unlocked (disarmed) without the remote or car keys 
with this function. Simply input the 4 digit pass-code by knocking on the Easy Door 
Lock Sensor on the front windshield.
** On the pager model (E8-B), knocking twice on the sensor will send a call signal to 
the pager remote. However, it will not operate when the vehicle is on the ON position 
nor when the engine is running.
LED Light
The 10 digit blue LED displays various functions such as arming, disarming, valet 
mode and emergency status (panic, shock, and theft).
➢ 
Dual Shock Sensor (CN6)
Install the sensor in a central loca-
tion and adjust its sensitivity after 
opening the door in accordance 
with different shocks and status of 
LEDs on the shock sensor. It sens-
es shocks by two steps (strong and 
weak shock).
➢
