Installation Manual indd

 CN9/3
VIOLET 
(-250mA) STARTER KILL
This wire supplies a (-) 250mA ground as long as the system is armed.
 CN9/4
BLANK N/A
 CN9/5
GREY/BLACK 
(-250mA) AUTO LIGHT CONTROL OUTPUT
Utilize this option to stop the auto light function in remote start, reservation start, 
and turbo start modes.
Autolight control 
(gray/black)
Door trigger pin in 
driver seat
➢

LF Module - Smart Door (CN10)
Mount the LF module on the front windshield (if the LF module is mounted under 
the dash, it decreases the transmitting 
distance). When the Smart Remote is
within the communication range (6 - 8 feet) 
of the LF module, it will unlock the vehicle.
When the Smart Remote is not detected in 
the communication range (6 - 8 feet),
the vehicle will lock within 12~15 seconds.
Note
The Smart Door function mode can be activated from the remote. Simply hold the 
unlock button for 3 seconds to activate the Smart Door mode.

---

16
INSTALLATION GUIDE
17
INSTALLATION GUIDE
U S A
U S A
➢

Temperature Sensor (CN11): 
E8-B ONLY
This sensor senses the interior temperature of the vehicle. Do not mount the 
sensor on the floor or the body of the vehicle.
2. Selection For Automatic and Manual 
Transmission 
The Jumper wire inside the cover of the main unit is used for Manual transmission 
vehicles. If the unit is installed on an Automatic transmission vehicle, simply cut 
the Jumper wire.
WARNING!
 
Do not reconnect the Jumper wire once it has been cut. It will 
void all warranty and it is very unsafe.
3. Alternator Sensor
1. Dip Switch